Grouts & Anchors Systems

KingGrout PG90^®

High strength pourable epoxy resin grout.

⬇ Download TDS Request a Quote →

Mixed density

2.00 ± 0.05 g/cm3

Water absorption

ASTM: ≤ 0.1% C413

Working life

≈ 2 hr @ 25⁰C

Coverage

10 litre per 20 kg …

Packaging

Pack

Standards

4 cited

ASTM 50 · ASTM D2369

Overview

KingGrout PG90 is a three component, high strength, free flowing, epoxy resin grout. KingGrout PG90 is suitable for grouting gaps with thicknesses between 10 – 150 mm at ambient temperatures between 10 - 40oC.

Applications

KingGrout PG90 is ideally designed for use in the following applications:
Machine base plates
Heavy crane rails
Pile top waterproofing
Bearing plinths
High speed turbines
Grouting areas where occasional chemical spillage may occur

Advantages

Resistant to dynamic loading
Non-shrink and low creep characteristics under continuous loading
Exceptionally high compressive, flexural and tensile strengths
Extremely dense
Exceptional bond to concrete and steel surfaces
Good chemical resistance
High early strength development allowing for rapid installation

Technical Properties

Property	Value	Standard
Compressive strength	ASTM ≥ 95 MPa @ 7 days C579	—
Flexural strength	EN: ≥ 30 MPa @ 7 days 13892-2	—
Tensile strength	≥ 15 MPa @ 7 days	BS 6319-7
Mixed density	2.00 ± 0.05 g/cm3	—
Recommended working	10 - 40oC	—
ambient temperature	Crack formation @ 150 mm, No cracks or bleeding	—
40oC		—
Peak exothermic	50 ± 2oC @ 40oC	—
temperature		ASTM D2471
Peak exothermic time	± 5 min @ 40oC D2471	ASTM 50
Water absorption	ASTM: ≤ 0.1% C413	—
Working life	≈ 2 hr @ 25⁰C	—
VOC	: < 10 g/ltr (complies with LEED) Mix the two components for 2 minutes. The filler should be gradually added while mixing. Mixing should continue for 3 minutes or until a uniform consistency obtained.	ASTM D2369