KingFloor EP200T®
Heavy duty epoxy topping for floor surfaces applied at 5 - 15 mm.
Overview
KingFloor EP200T is a three-pack solvent free, epoxy- based topping that provides floor surfaces with a seamless, hygienic and cosmetically attractive finish. KingFloor EP200T is applied by trowel and can be coved and laid to falls and has a very good durability towards pedestrian and vehicular traffic. It also has very good resistance towards many of the chemicals commonly found in an industrial environment (consult our Technical department for further details). KingFloor EP200T has a finish that provides very good slip resistance and can be supplied in a natural colour and variety of colours (consult our Sales Department for details).
Applications
- KingFloor EP200T is used to provide a hygienic, dense and extremely hard wearing surface for concrete floors for a wide range of applications such as:
- Heavy industry factories
- Paint workshops
- Steel works
- Dairies
- Chemical factories
- Oil refineries
- Freezers and refrigerated storage
Advantages
- Extremely hard wearing system
- Solvent free
- Non-slip
- Available in a wide range of attractive colours
- Resist a wide range of chemicals, consult KINGKRETE technical department for more details
- STANDARDS KingFloor EP200T complies with EN 13813, SR- B2.0- AR0.5-IR10
Technical Properties
| Property | Value | Standard |
|---|---|---|
| Specific gravity | 2.1 ± 0.1 | — |
| Pot life | 1 hr | — |
| Compressive strength | BS: > 75 MPa 6319, Part 2 | — |
| Flexural strength | , > 20 MPa Part 3 | BS 6319 |
| Tensile strength | ,: > 9 MPa Part 7 | BS 6319 |
| Shore D hardness | ASTM: > 80 D2240 | — |
| Foot traffic | After 24 hr | — |
| Vehicular traffic | After 72 hr | — |
| Chemical curing | 7 days | — |
| Bond strength | 2 MPa (concrete failure) | — |
| Maximum wear depth | BS EN 0.05 mm 13892-4 | — |
| Impact resistance | ISO: > 10 N.m 6272-2 | — |
| VOC | < 20 g/ltr Concrete floors must have a minimum compressive strength of 25 N/mm² and a maximum concrete relative humidity of 80% (max. moisture content of 4%), relative humidity can be measured by using hygrometers. Concrete relative humidity should be less than 80% for concrete of 28 days old or more, for low W/C ratio concrete floors, 80% hygrometer reading or less can be achieved before 28 days age. | — |
Standards & Approvals
Usage & Packaging
KingFloor EP200T is available in 30 kg packs. KingFloor Primer is available in 5 kg packs. 5 - 15 mm and above.
KingFloor EP200T: Approximately 1.4 m²/kit @ 10 mm thick. KingFloor Primer: 5 m²/kg.
Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature
Pack