KingFloor EP Screed®
Two-component transparent epoxy binder for creating aggregate screed system.
Overview
KingFloor EP Screed is a two-component, solvent-free transparent epoxy binder designed for creating aggregate surface systems. The system provides a wide variety of finishes which are dependent on the type, colour and size of the used aggregates along with their mixing proportion with the resin. The system can be applied at 5 - 50 mm thickness based on the size of aggregate used.
Applications
- KingFloor EP Screed is used to provide an extremely hard wearing natural looking floors for a wide range of applications such as:
- Public footpaths
- Driveways and car parks
- Pool surrounds
- Garden paths
- Decorative landscaping
- Shopping centers
- Residential buildings
Advantages
- Hard wearing system
- Solvent free
- Non-slip
- Permeable
- Natural appearance
- Low maintenance
- Enhances the natural color of aggregate used
- Permeable (dependent on mix design and application)
- Resistant to a wide range of chemicals, consult with KINGKRETE technical department for more details
Technical Properties
| Property | Value | Standard |
|---|---|---|
| Appearance | Transparent liquid | — |
| Mixed density | 1.1 ± 0.1 g/cm3 | — |
| Pot life | 30 - 50 min | — |
| Compressive strength | BS: ≥ 38 MPa @ 7 days 6319, part 2 | — |
| VOC | : ≤ 20 g/ltr (comply with LEED) Concrete floors must have a minimum compressive strength of 25 N/mm² and a maximum concrete relative humidity of 75% (max. moisture content of 4%), relative humidity can be measured by using hygrometers. Concrete relative humidity should be less than 75% for concrete of 28 days old or more, for low W/C ratio concrete floors, 75% hygrometer reading or less can be achieved before 28 days age. Unsound layers and contaminated concrete surfaces must be prepared using mechanical surface removing equipment. In case of areas deeply contaminated by oil or grease, such areas should be treated with hot compressed air. | ASTM D2369 |
Standards & Approvals
Usage & Packaging
KingFloor EP Screed (neat resin) is available in 30 kg packs. The mixing ratio for the resin mix with the aggregate is highly dependent on the aggregate size and shape, a recommended start-up mix ratio is as follows: Resin “base and hardener” 1 kg: Aggreg
The actual coverage rate of KingFloor EP Screed depends on the size of the aggregate and the mixing proportion between the resin and aggregate. However, the approximate coverage rate of the mixed product is in range of 10 m2 per 100 kg mixed screed at 5 m
Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature
Pack