KingHard C500®
Dry shake monolithic concrete floor hardener for stamped concrete.
Overview
KingHard C500 is a premixed dry shake floor hardener Colour: applied over freshly laid concrete. KingHard C500 is formulated from selected graded aggregate, cement and Maximum special additives to provide a non-metallic, non-oxidising, 13892-4 dense and smooth surface with high abrasion and wear resistance. Flexural 13892-2 KingStamp RA100 is a premixed special hydrophobic releasing powder mixed with high quality pigments. Compressive EN
Applications
- Parking areas
- Warehouses
- Side-walks
- Patios and garden landscaping
Advantages
- Good resistance to wearing and abrasion
- Easy to apply
- Provides monolithic floor
- Premixed, ready to use
- U.V. Stable pigments
- Available in wide range of colours
- Decorative finish as a finished stamped concrete floor
- STANDARDS KingHard C500 complies with EN 13813, Class CT-C35- F5-AR6
Technical Properties
| Property | Value | Standard |
|---|---|---|
| Comes in different selected colours | ||
| wear depth | BS EN 0.6 mm | — |
| strength | BS EN: > 5 MPa | — |
| strength | BS: > 35 MPa 13892-2 The remaining quantity of KingHard C500 is applied evenly onto the surface and shall be floated as above. Using a “Fresno” or blue steel trowel, the surface should be trowelled well to eliminate any float marks and to achieve the final finish. Prior to imprinting, the trowelled slab should be covered with powder release agent “KingStamp RA100” at a rate of 5 to 7 m2/kg. The crew should be equipped with a minimum of 6 or more mats and a floppy. Adequate and enough hand tools should be available to complete the whole area. Using a reference line, begin by placing the first mats using this line and move across the slab. When stamping, the mats should be tamped using a special pounder without delay. The finished slab should be left for a minimum of 2 – 3 days to set. All excess powder release agent “KingStamp RA100” should be brushed off and then cleaned using pressurized water. The slab must be completely dry before the sealer coat is applied. The surface must be sealed using KingStamp AC100. The first coat should be applied at a rate of 6 – 10 m2/ Ltr. A second coat can be applied if required after the first coat has dried. | — |
Usage & Packaging
KingHard C500 is available in 25 kg bags. KingStamp RA100 is available in 10 kg bags. KingStamp AC100 is available in 5 and 25 litre pails.
Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature
Pail, Bag