KingFloor PA500®
Polyaspartic aliphatic flooring System.
Overview
KingFloor PA500 is a two-component, is a high performance, solvent free, rapid curing flooring product based on the latest polyaspartic/ polyurea technologies. KingFloor PA500 provides excellent colour, has matt finish and is resistant to most fuels, oils, solvents and cleaners. KingFloor PA500 can be rapidly and consistently applied using airless spray, low pressure plural component, roller, squeegee or notched trowel application. With a tack free time of approx. 60 min re-use times are incredibly short saving customers valuable producti on time.
Applications
- KingFloor PA500 is used as protective, decorative, high chemical resistance and hard wearing floor coating system for a wide range of applications including:
- Concrete garage floors, patios and walkways
- Car park decks
- Warehouse flooring
- Automotive sales and service areas
- Aircraft hangers
- Restaurants kitchens and dining areas
- Retail shops and shopping malls
- Hospital flooring
Advantages
- Excellent colour and gloss retention
- Excellent abrasion resistance
- Excellent working time
- Excellent adhesion to concrete substrates
- Excellent chemical resistance
- Resistant to most chemicals, solvents, acids and caustics
- Can be used for in-door and outdoor applications
- Stable over a wide temperature range
- Displays good flexibility and impact resistance compared to standard epoxies
- Excellent for grind and seal applications
- Cures to a very clear finish when not pigmented
Technical Properties
| Property | Value | Standard |
|---|---|---|
| Colour | Clear, can be pigmented | — |
| Mixed density | 1.1 ± 0.1 g/cm3 | — |
| Pot life @ 20oC | 60 - 80 min | — |
| Tack free time | 1 hr | — |
| Pedestrain traffic time | Light 2 - 4 hr 5 - 8 hr Heavy | — |
| Over coating time | 8 hr | — |
| Application temperature | 5 - 50oC | — |
| Shore D Hardness | ASTM: 85 ± 5 D2240 | — |
| Tensile strength | * ASTM: 35 ± 5 MPa D638 | — |
| Elongation at break | ASTM ≥ 80% D638 | — |
| Bond strength on concrete | ≥ 3 MPa (concrete failure) | ASTM D4541 |
| Taber abrasion resistance | < 28 milligram (1000 g, 1000 cycle) , weight loss CS17 wheel | ASTM D4060 |
| Impact resistance | Direct/: No cracking reverse 18MPa/18MPa *when applied as a full system with recommended primer. | ASTM D2794 |
| Note | All test results and timings provided are based on tests carried out in laboratory conditions. Substrate and atmospheric temperature, humidity, condition and application thickness will all influence these results and therefore they must be used as a guide only. Loose or unsound material should be removed. Sweep and vacuum to remove all dust and debris. Steel substrates should be prepared to a class 2 ½ near white blast finish with a surface profile of 80 microns. Mask all adjacent surfaces and protect the surrounding area from overspray. Do not apply unless the substrate temperature is 3°C or greater than dew point. | — |
Standards & Approvals
Usage & Packaging
KingFloor PA500 is available in 20 x 20 litre buckets and 200 x 200 Litre drums.
Approximately 0.1 L/m2 to achieve a DFT of 100 μm per coat. However, coverage may vary depending on the substrate and surface porosity.
Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature
Drum, Bucket